A striking appearance in any room and an all-rounder when it comes to energy efficiency
Classe di efficienza energetica
NEXO 185, the largest of the successful NEXO series, is an imposing appearance and a real heat source. Thanks to the customized-concept, NEXO can be assembled from various components. Create your own personal one-off! There are six elegant colours, seven high-quality handles, various top plates and...
Mostra tutto
NEXO 185, the largest of the successful NEXO series, is an imposing appearance and a real heat source. Thanks to the customized-concept, NEXO can be assembled from various components. Create your own personal one-off! There are six elegant colours, seven high-quality handles, various top plates and various firebox door and side window variants to choose from.
All Attika stoves and fireplaces are sold through our network of qualified dealers. If you are interested in our products, please contact your local dealer. They will provide you with a customised offer for the desired product, including individual installation.
Which air control should I choose for my stove (CleverAIR™, ElectronicAIR™, manual)?
The CleverAIR™ and ElectronicAIR™ automatic air control systems from Attika regulate the air supply to your stove. The right amount of air is supplied to the inside of the stove when the firebox heats up - either mechanically or electronically. Automatic burn-off control therefore has significant ecological advantages because it completely eliminates operating errors that can occur when manually adjusting the fresh air supply.
Remember that the chimney is decisive and therefore responsible for the draught behaviour of the stove. If the stove is connected to a flue pipe that is too large, the manual air control has the advantage that it can remain fully open for longer periods of time. This is important because warm air is known to rise.
If this air (smoke) enters a larger volume, it cools down more quickly, which slows down the flow rate. As a result, the air does not escape and flows back into the room. When choosing the right air control, it is best to contact your local specialist partner. They will be able to advise you on your personal requirements and the exhaust system already installed.
Can I install a stove or fireplace in a Minergie or low-energy house?
Yes, of course. To do this, the stove must be installed room air independent. This means that the fresh air required for combustion is not taken from the room where the stove is located, but is supplied to the stove in a controlled manner from outside via a pipe/duct connection.
In almost all parapet stoves and fireplace inserts, this connection can be fed either through the floor or through the rear wall using the so-called AIR system. Thanks to the AIR system, you can easily install your stove in a low-energy or Minergie house. Please be sure to observe the country-specific requirements.